ASIO control

ReValver HP, MkIII, and MkIII.V Product Support.

Moderators: Michael Ljunggren, ReValver Support Team

Post Reply
New Member
Posts: 3
Joined: Sat Nov 03, 2018 1:05 pm

ASIO control

Post by sleestak » Sat Nov 03, 2018 1:11 pm


If I run Revalver and set device to my Line 6 POD (in tuner mode) I can use and hear Revalver. If I then call up Pro Tools it indicates there is an issue with audio. If I exit Revalver and load Pro Tools the Line 6 POD shows up in Pro Tools and I can record, but if I then call up Revalver it indicates there is an ASIO issue. How do I run both pieces of software at the same time through the same audio interface? Currently, the first one selected takes control of the device and then the other cannot see it (and vice versa).


Post Reply