Hi!
Where could I find RS232 codes for Digitool? I have to use 3rd party control such as Crestron to adjust volume levels.
Thanks!
RS232 codes for Digitool
-
- Member
- Posts: 4478
- Joined: Mon Oct 27, 2008 3:50 pm
Re: RS232 codes for Digitool
You can communicate directly with the Digitool MX via the HyperTerminal in Windows.
You get there by going to the start menu, then Accessories, then communications, then HyperTerminal. If you are familar with Crestron, you should be able to take control from that window.
E-mail me if you need further assistance.
You get there by going to the start menu, then Accessories, then communications, then HyperTerminal. If you are familar with Crestron, you should be able to take control from that window.
E-mail me if you need further assistance.
- USDCMaryland
- New Member
- Posts: 2
- Joined: Fri Jun 03, 2011 11:43 am
Re: RS232 codes for Digitool
What would be the exact coding for re-calling Presets?
Controlling Master Volume, and separate channel audio?
I've tried reading the little RS-232 Manual for the Digitool and its no help.
And I wouldnt know where to start using the hyper-terminal.
I'm trying to teach myself all this stuff since my company is in major $ crunch and training is not happening. Or calling in an outside company.
Controlling Master Volume, and separate channel audio?
I've tried reading the little RS-232 Manual for the Digitool and its no help.
And I wouldnt know where to start using the hyper-terminal.
I'm trying to teach myself all this stuff since my company is in major $ crunch and training is not happening. Or calling in an outside company.
Re: RS232 codes for Digitool
I'm using a crestron controller to control the Digitool mx audio multi processor..is there any RS232 codes for it ? i can't find the manual of it as well?
Thanks
Thanks