One of the IP-Six Amp that is used at our church has two monitors (one per channel)
lately Channel A (monitor on this channel) drops in volume and cuts off completely. At first I thought it was the speaker or the channel A cable but, I have tested the cable by simply swapping channels and B continues to work as it should.
I have read up on the thermal protection and air ventilation/cooling requirements - because this unit is located inside a portable wooden rack with the mixer and other units inside the sanctuary(in an open area) - One of the sound individual was concern about the air flow - there is a door on the back of the rack and a glass door in the front. Should this be an issue?
Would the protection mechanism only protect one channel if needed (even though I would think that if it were an air flow issue both channels would be affected) or is it designed to shutdown both channels.
Thank you.
tony
IP-six channel question
This forum is for talking about all kinds of AA power amplifiers.
Return to “AA Power Amplifiers”
Jump to
- Rules and Guidelines
- ↳ Peavey® Forum Rules
- General Discussion
- ↳ Club Peavey
- Amplifiers
- ↳ Guitar Amplifiers
- ↳ Vypyr & Sanpera
- ↳ Bass Amplifiers
- ↳ Keyboard Amplifiers
- Instruments
- ↳ Peavey Guitars
- ↳ Peavey Bass Guitars
- Pro Audio
- ↳ Speakers/Enclosures
- ↳ Power Amplifiers
- ↳ Mixers
- ↳ Processors/Effects
- ↳ VSX
- ↳ Microphones
- ↳ Latest News
- ↳ AmpKit Link
- ↳ XPort USB Guitar Interface
- ↳ Architectural Acoustics Club
- ↳ AA Mixers
- ↳ AA Modules
- ↳ AA Power Amplifiers
- ↳ AA Signal Processors
- ↳ AA Speakers/Enclosures
- ↳ ReValver Discussions
- ↳ ReValver Support
- ↳ ReValver Presets
- ↳ ReValver Mk II
- ↳ Pristine Sounds