VSX26 Xover Setting for QW4F + Versarray 218

A forum for discussing the VSX and share settings
Post Reply
mtmusic1
New Member
Posts: 3
Joined: Mon Dec 13, 2010 9:41 am

VSX26 Xover Setting for QW4F + Versarray 218

Post by mtmusic1 » Mon Jul 09, 2018 9:54 pm

Hello, Please Help Me.

I need the best Xover setting or Xover frequency cuts. I have a Peavey system: QW4F + Versarray 218 Sub (each side).

What is the recommended filter Crossover/Bandpass for this system? ¿Butterworth, Bessel or Linkwitz-Riley?
In this time I use Linkwitz-Riley 12 for all Xover points, but I have doubts.

This is my parameters chart:

1. Versarray 218 (Low range). Type: L-R 12, Freq: 30 Hz. Level 10.

2. Versarray 218 (High range). Xover point Type: L-R 12, Freq: 120 Hz.

3. QW4F (Low range). Xover point Type: L-R 12, Freq: 120 Hz. Level 0 Db

4. QW4F (High range). Type: Flat, Freq: 20000


Thank you for your time and answers.

Mike Tost.

Dano0369
Member
Posts: 247
Joined: Tue Jul 19, 2011 12:35 pm

Re: VSX26 Xover Setting for QW4F + Versarray 218

Post by Dano0369 » Tue Jul 10, 2018 10:34 am

Hey Sir; hope you are getting it worked out. what amps are you using? your way out of line on the shelf of the bass crossover. I would consider +6 to be very hot for aux subs. there is a plethora of preset on the web site. are you using a 26 or a 48 or the new e models ? DP
Dano0369

Stryker57
Member
Posts: 916
Joined: Fri Aug 20, 2010 9:39 am
Location: Cincinnati,Ohio

Re: VSX26 Xover Setting for QW4F + Versarray 218

Post by Stryker57 » Tue Jul 10, 2018 3:12 pm

dont forget the cd horn eq

Dano0369
Member
Posts: 247
Joined: Tue Jul 19, 2011 12:35 pm

Re: VSX26 Xover Setting for QW4F + Versarray 218

Post by Dano0369 » Tue Jul 10, 2018 3:37 pm

hey sir; try this= [email protected] 0.00 level, [email protected] 90 this for the vr218 . [email protected] 70 0.00level, [email protected], [email protected] -0.5 level [email protected] make a 0.7bw cut to -3.0 @ 2700hz. you want the bottom cone in the qw4 to act as a bridge between the vr and the qw4 , else its not doing anything its own internal cross will send it down to 55. with the settings your using its not doing anything. Good luck . I would suggest cs4080hz or ipr II 7500 or prolite 7.5 . I normally use a pro9 200 on subs Good luck DP
Dano0369

Post Reply