VYPYR VIP 1 almost no sound from speaker
Posted: Wed Aug 05, 2020 1:14 pm
I just got this little VIP 1 used and it worked great for about a day, just messing around with settings and trying to figure it out. Then I switched it to the bass option and turned up the master volume, because the higher strings wouldn't register at all with the gate, and it just went silent.
I tried turning it off and on, I did a factory reset, tried different cords and guitars. With headphones plugged in there's still sound, but almost nothing through the speaker. If you crank the master volume you can still hear a very slight bit of sound coming out but only at full volume. I thought it was trashed but then, briefly, the sound worked again. Until i switched to one of the other amp presets (forgetting they had the post gain at max by default) and the loud noise that came out shut the speaker off again.
I can see the wires plugged into the speaker seem tight but I haven't taken it apart to see the other end. Has anyone experienced this or would anyone have any ideas as to what I might need to do? Thanks in advance.
And as I'm typing this the speaker started working again, but I'm sure it will eventually cut out.
I tried turning it off and on, I did a factory reset, tried different cords and guitars. With headphones plugged in there's still sound, but almost nothing through the speaker. If you crank the master volume you can still hear a very slight bit of sound coming out but only at full volume. I thought it was trashed but then, briefly, the sound worked again. Until i switched to one of the other amp presets (forgetting they had the post gain at max by default) and the loud noise that came out shut the speaker off again.
I can see the wires plugged into the speaker seem tight but I haven't taken it apart to see the other end. Has anyone experienced this or would anyone have any ideas as to what I might need to do? Thanks in advance.
And as I'm typing this the speaker started working again, but I'm sure it will eventually cut out.