Sanctuary S-32 Firmwear

This forum is for talking about all types of Peavey mixers.
Post Reply
Bcfischer
New Member
Posts: 1
Joined: Sun Sep 23, 2018 6:49 pm
Location: Duluth, Minnesota

Sanctuary S-32 Firmwear

Post by Bcfischer » Sun Sep 23, 2018 7:08 pm

What is the current/highest level firmwear for the S-32 mixer? I believe mine is on 1.33.

If that is not the highest level, where would one find firmwear updates for the Sanctuary series?

Thanks and take care,

Brian
Duluth, Minnesota

jim h
Member
Posts: 657
Joined: Fri Sep 12, 2008 11:20 pm

Re: Sanctuary S-32 Firmwear

Post by jim h » Mon Sep 24, 2018 10:52 am

1.33 is actually the kernel version.

The last released firmware for the S32 is 1.30, but you can actually install beta versions released for the FX mixers. That would be 1.31 rev3 beta.

If you email me through the forum, I can send you updated files and instructions.

Inovations Encinas
New Member
Posts: 2
Joined: Thu Feb 04, 2021 10:30 pm

Re: Sanctuary S-32 Firmwear

Post by Inovations Encinas » Thu Feb 04, 2021 10:48 pm

Bcfischer wrote:
Sun Sep 23, 2018 7:08 pm
What is the current/highest level firmwear for the S-32 mixer? I believe mine is on 1.33.

If that is not the highest level, where would one find firmwear updates for the Sanctuary series?

Thanks and take care,

Brian
Duluth, Minnesota
I need help finding this firmware for my Peavey Sanctuary s32 any chance someone email me a copy of it?

jim h
Member
Posts: 657
Joined: Fri Sep 12, 2008 11:20 pm

Re: Sanctuary S-32 Firmwear

Post by jim h » Fri Feb 05, 2021 1:19 pm

I can email it to you.

Inovations Encinas
New Member
Posts: 2
Joined: Thu Feb 04, 2021 10:30 pm

Re: Sanctuary S-32 Firmwear

Post by Inovations Encinas » Fri Feb 05, 2021 1:43 pm

Thank you Jim, The problem I have is that the mixer has a blank screen, I tried to perform a factory reset but still a blank screen. It light up but is blank. The mixer sliders are not working. I can control the volume on the inlet side but not on any of the volume faders or apply any effects. I did find the information on line
And the instructions advising to load KRN_0133 zip and PVY BOOT zip before loading the PVY_V130 zip I think I can load it directly out of my computer using a printer USB cable.

I am new to this type of forum and do not know how to navigate in it. Still haven’t figured out how to email you. This forum has been a real blessing and really helped direct me to find the firmware just by reading the input provided I was trying to look it up for the Sanctuary S32 and was not seeing it until I read you could use the FX Firmware.

Post Reply