What is the current/highest level firmwear for the S-32 mixer? I believe mine is on 1.33.
If that is not the highest level, where would one find firmwear updates for the Sanctuary series?
Thanks and take care,
Brian
Duluth, Minnesota
Sanctuary S-32 Firmwear
Re: Sanctuary S-32 Firmwear
1.33 is actually the kernel version.
The last released firmware for the S32 is 1.30, but you can actually install beta versions released for the FX mixers. That would be 1.31 rev3 beta.
If you email me through the forum, I can send you updated files and instructions.
The last released firmware for the S32 is 1.30, but you can actually install beta versions released for the FX mixers. That would be 1.31 rev3 beta.
If you email me through the forum, I can send you updated files and instructions.
-
- New Member
- Posts: 2
- Joined: Thu Feb 04, 2021 10:30 pm
Re: Sanctuary S-32 Firmwear
I need help finding this firmware for my Peavey Sanctuary s32 any chance someone email me a copy of it?
Re: Sanctuary S-32 Firmwear
I can email it to you.
-
- New Member
- Posts: 2
- Joined: Thu Feb 04, 2021 10:30 pm
Re: Sanctuary S-32 Firmwear
Thank you Jim, The problem I have is that the mixer has a blank screen, I tried to perform a factory reset but still a blank screen. It light up but is blank. The mixer sliders are not working. I can control the volume on the inlet side but not on any of the volume faders or apply any effects. I did find the information on line
And the instructions advising to load KRN_0133 zip and PVY BOOT zip before loading the PVY_V130 zip I think I can load it directly out of my computer using a printer USB cable.
I am new to this type of forum and do not know how to navigate in it. Still haven’t figured out how to email you. This forum has been a real blessing and really helped direct me to find the firmware just by reading the input provided I was trying to look it up for the Sanctuary S32 and was not seeing it until I read you could use the FX Firmware.
And the instructions advising to load KRN_0133 zip and PVY BOOT zip before loading the PVY_V130 zip I think I can load it directly out of my computer using a printer USB cable.
I am new to this type of forum and do not know how to navigate in it. Still haven’t figured out how to email you. This forum has been a real blessing and really helped direct me to find the firmware just by reading the input provided I was trying to look it up for the Sanctuary S32 and was not seeing it until I read you could use the FX Firmware.