Ipr2 5000 dsp one output no light no out.
Ipr2 5000 dsp one output no light no out.
I have three Ipr2 5000 dsps, two of the {one is New} have no output or light on one channel, It is the same channel, I thought maybe it was a wire downstream or something, but cant find a continuity problem Wondered if there was a balance or load detector in them that would cause them to close a channel if there was something downstream or if the input even though the light shows good could be somehow causing them to block and refuse to output. I could really use a detailed Schematic and a troubleshooting guide for this problem. It is about 100 miles to the closest service center so I may just pack up them up and ship them to someone to get them checked. I don't want to do it and have a downstream problem That is a simple fix.
Lost in the Search for the fading dream.
- JamesPaul
- Member
- Posts: 2477
- Joined: Fri Sep 12, 2008 7:28 pm
- Location: Moving Towards Adam Brown's State
Re: Ipr2 5000 dsp one output no light no out.
If you call Peavey, they will email you the schematics. They are a little shorthanded at the moment, so it will be best to speak with someone as opposed to leaving a message. At last report, between 1pm and 5pm Central Time were the better hours. The number is on the website, but 877-732-8391.
James Paul's PeaveysEnzo wrote:I find if the amp is working, that is a good point to stop fixing it.
Decade, Classics, Ecoustic, Windsors, VYPYR, Triple XXX, XXL, VKs, Bandit, JSXs, VIP, Piranha and a Penta.