Hi all, I have recently bought a USA Cirrus, an early one from what I gather, serial number starting with 1012.
I need to set it up as it has way too much relief but due to the short truss rod access route I cannot get anything in there to see what size alan wrench I need to use.
It seems to be about 4mm but I suspect it is imperial, cutting down an alan wrench is not a problem, I just need to know what size I should be using, in case someone else has started o round it out.
Can anyone tell me what size tool I should be using?
Cirrus truss rod tool size
Re: Cirrus truss rod tool size
Hi. 5/32 inch.
-
- Member
- Posts: 325
- Joined: Wed May 28, 2014 6:05 pm
- Location: Scotland
Re: Cirrus truss rod tool size
It's 4mm.
Do Not Use SAE hex keys,they are a tiny bit smaller and will round the hex nut.
Do Not Use SAE hex keys,they are a tiny bit smaller and will round the hex nut.
Axcelerator,B-90,B-Quad,Cirrus,Dyna,Dyna/Unity,Foundations,Forum,Fury,Gbass,Grind,International,midibase,Milestone III, Millenniums,Patriot,Resolite,RJ-IV,Sarzo,3 T40,T45,T20,TL-5,Tragic,Unity,Void,Zephyr5,3 Zodiac.