Cirrus truss rod tool size

This forum is for discussions on all kinds of Peavey basses.
Post Reply
Squidly
New Member
Posts: 1
Joined: Mon Apr 16, 2018 5:17 pm

Cirrus truss rod tool size

Post by Squidly » Fri Jun 19, 2020 6:33 pm

Hi all, I have recently bought a USA Cirrus, an early one from what I gather, serial number starting with 1012.
I need to set it up as it has way too much relief but due to the short truss rod access route I cannot get anything in there to see what size alan wrench I need to use.
It seems to be about 4mm but I suspect it is imperial, cutting down an alan wrench is not a problem, I just need to know what size I should be using, in case someone else has started o round it out.
Can anyone tell me what size tool I should be using?

Bubarock
New Member
Posts: 3
Joined: Sun Jun 21, 2020 11:58 am

Re: Cirrus truss rod tool size

Post by Bubarock » Fri Jun 26, 2020 8:40 am

Hi. 5/32 inch.

kodiakblair
Member
Posts: 273
Joined: Wed May 28, 2014 6:05 pm
Location: Scotland

Re: Cirrus truss rod tool size

Post by kodiakblair » Mon Jun 29, 2020 10:01 am

It's 4mm.

Do Not Use SAE hex keys,they are a tiny bit smaller and will round the hex nut.
Axcelerator,B-90,B-Quad,Cirrus,Dyna,Dyna/Unity,Foundations,Forum,Fury,Gbass,Grind,International,midibase,Milestone III, Millenniums,Patriot,Resolite,RJ-IV,Sarzo,3 T40,T45,T20,TL-5,Tragic,Unity,Void,Zephyr5,3 Zodiac.

Post Reply