KB 60 connection to multi-fx devices

This forum is for talking about Peavey keyboard amplifiers.
Post Reply
markg999
New Member
Posts: 1
Joined: Thu Mar 02, 2023 8:08 pm

KB 60 connection to multi-fx devices

Post by markg999 » Thu Mar 02, 2023 8:17 pm

Hi All,

KB 60 has "Pre EQ Patch" and "Preamp Out/PowerAmp In" connections.

I have a Line 6 POD (Guitar effects box) that I'm not sure how to connect properly to this amp.

In addition I want to know if I have a distortion and Wah pedals, what is the correct connectivity. The KB60 manual is really bad.

Thanks!
Mark

User avatar
dak
Member
Posts: 428
Joined: Fri Dec 24, 2021 7:20 am
Location: Germany

Re: KB 60 connection to multi-fx devices

Post by dak » Fri Mar 03, 2023 7:20 pm

Preamp output will have too high levels for a guitar effect box. Try the Pre EQ Patch input instead. You'll need a patch cable for that, with a TRS plug on one side (going into the KB60) and two cables with TS plugs on the other side, one for the input side of your effect box, one for the output side.

That's if you want the effects on all channels. If you just want them on one channel, you put them before the channel input.

Post Reply