Does anyone know if the DI out on these combo amps is Pre or Post?
I am assuming Post but it didn't specify in the manual that I could notice.
Thanks!
DI for MAX 100 and MAX 150 Combos
-
Bassguitarist1985
- Member
- Posts: 717
- Joined: Fri Sep 12, 2008 6:03 pm
- Location: Southwestern CT
- Contact:
Re: DI for MAX 100 and MAX 150 Combos
Pre EQ, page 7 of the manual
Direct Interface (DI): Pre-EQ, unity buffer
Output Signal Level = Input Level – 10dB Noise Floor = 0.95mV(rms) = -78dBu
Direct Interface (DI): Pre-EQ, unity buffer
Output Signal Level = Input Level – 10dB Noise Floor = 0.95mV(rms) = -78dBu
Pro Audio 16FX2, PV6USB, 2xQF131, QF215, 2x SP2, 2xSP118, 2xPV1600, PV3800, 4xKPC15MP
Bass - Grind 6 NTB 410TVX, 115BVX, MAX700, 210TVX, MiniMega, VB-2, VB-3, VB-MA
Bass - Grind 6 NTB 410TVX, 115BVX, MAX700, 210TVX, MiniMega, VB-2, VB-3, VB-MA
-
LarmanKhemka
- New Member
- Posts: 2
- Joined: Tue Sep 26, 2023 1:08 am
Re: DI for MAX 100 and MAX 150 Combos
You're on the right track! For most combo amps, the DI output is post the preamp section. This means it sends the signal after it's been shaped by your EQ, gain, and effects settings.
Since the manual didn't specify, checking online reviews or forums for your specific amp model can be helpful. But in general, DI outs on combo amps are most likely post-preamp.
Since the manual didn't specify, checking online reviews or forums for your specific amp model can be helpful. But in general, DI outs on combo amps are most likely post-preamp.