My peavey m- 2600 poped and went out and now blows fuse what should I look for

This forum is for discussions on all kinds of Peavey bass amplifiers.
Post Reply
Jdpassmore1
New Member
Posts: 2
Joined: Mon Feb 01, 2016 10:10 am

My peavey m- 2600 poped and went out and now blows fuse what should I look for

Post by Jdpassmore1 » Mon Feb 01, 2016 10:15 am

My peavey M- 2600 power amp was slightly buzzing then in later poped and went off . now it blows fuses on back what should I look for.

User avatar
Enzo
Member
Posts: 9535
Joined: Fri Sep 12, 2008 10:24 pm
Location: Lansing, Michigan

Re: My peavey m- 2600 poped and went out and now blows fuse what should I look for

Post by Enzo » Mon Feb 01, 2016 6:05 pm

First, shorted output transistors on a channel.

jonny2scoops
New Member
Posts: 2
Joined: Sun May 29, 2022 7:20 pm

Re: My peavey m- 2600 poped and went out and now blows fuse what should I look for

Post by jonny2scoops » Sun May 29, 2022 7:55 pm

On mine it was one of the screws that hold the rubber feet on shorting the circuit board to ground (covered with a little grey rubber pad that had been pierced by the screw over time) I just chopped the end of the screw with a dremel.

Post Reply