hi all
I have mains and output transformers from 100W valve king that I'm using to build another amp - been looking at the schematic and need some confirmation from someone with more technical knowledge than myself please
I understand the heaters are DC rectified then the 6L6's wired in series and they're connected to the 12ax7's in parallel , so is the following [badly drawn] diagram correct ?
and does anyone know of a neat way of connecting the three 100uf capacitors between the 6L6's and ground ? - like can I wire them between pin 7 and pin 8 going to ground [via a 1R resistor] ?
thanks,
phil
valve king transformers
This forum is for talking about all kinds of Peavey guitar amplifiers.
-
- New Member
- Posts: 5
- Joined: Fri Feb 03, 2023 6:45 am
Jump to
- Rules and Guidelines
- ↳ Peavey® Forum Rules
- General Discussion
- ↳ Club Peavey
- Amplifiers
- ↳ Guitar Amplifiers
- ↳ Vypyr & Sanpera
- ↳ Bass Amplifiers
- ↳ Keyboard Amplifiers
- Instruments
- ↳ Peavey Guitars
- ↳ Peavey Bass Guitars
- Pro Audio
- ↳ Speakers/Enclosures
- ↳ Power Amplifiers
- ↳ Mixers
- ↳ Processors/Effects
- ↳ VSX
- ↳ Microphones
- ↳ Latest News
- ↳ AmpKit Link
- ↳ XPort USB Guitar Interface
- ↳ Architectural Acoustics Club
- ↳ AA Mixers
- ↳ AA Modules
- ↳ AA Power Amplifiers
- ↳ AA Signal Processors
- ↳ AA Speakers/Enclosures
- ↳ ReValver Discussions
- ↳ ReValver Support
- ↳ ReValver Presets
- ↳ ReValver Mk II
- ↳ Pristine Sounds