Hi all
I'm playing a Peavey XXX 120W Tube Head. Now i'm looking for a possibility to integrate the channelswitcher to a pedal board.
Is there any device/cable out there which can be used in combination with a looper? I want to be able to switch the amp channel within different "presets" on the switcher.
Thanky for any ideas and tipps.
Peavey XXX 120W channel switch over a looper
-
- New Member
- Posts: 1
- Joined: Wed Sep 21, 2022 10:08 am
- JamesPaul
- Member
- Posts: 2477
- Joined: Fri Sep 12, 2008 7:28 pm
- Location: Moving Towards Adam Brown's State
Re: Peavey XXX 120W channel switch over a looper
Welcome to the forum.
I am not aware of any such device or cable. I am confident you will have to set the knobs on the Clean, Crunch, and Ultra channels and those 3 "presets" are all you will get from a tone perspective. The footswitch is only switching relays inside the amp.
If you want more than 3 Triple XXX presets, you are likely looking at a Vypyr X. I use my VIP 3 and have 12 different presets for the Triple XXX model.
If you want to make your own the pinout is available here:
viewtopic.php?f=19&t=2464#p20317
I am not aware of any such device or cable. I am confident you will have to set the knobs on the Clean, Crunch, and Ultra channels and those 3 "presets" are all you will get from a tone perspective. The footswitch is only switching relays inside the amp.
If you want more than 3 Triple XXX presets, you are likely looking at a Vypyr X. I use my VIP 3 and have 12 different presets for the Triple XXX model.
If you want to make your own the pinout is available here:
viewtopic.php?f=19&t=2464#p20317
James Paul's PeaveysEnzo wrote:I find if the amp is working, that is a good point to stop fixing it.
Decade, Classics, Ecoustic, Windsors, VYPYR, Triple XXX, XXL, VKs, Bandit, JSXs, VIP, Piranha and a Penta.