Peavey Forum

This is the amplifier's switching frequency. There can be some visible on the output, but I'm not sure about 8 Volts. That sounds a little high to me, you could have some damaged components in the output filter.

When using the app, there are two places to adjust levels. There is the analog gain on the unit and there is digital gain that can be adjusted within the app.

And just to make everything sync'd up, are you turning App Mode on/off on the unit?

The PV6BT requires +15V DC.

The original (silver) PV6 and PV8 required 16VAC.

Yes, take the signal from the Record Out jacks. They are pre-master volume...so the master volume doesn't affect the level. However, you may need to adjust your balance between the channel levels and the master level. Think of it like this, the record out level is determined by the combination of th...

You can download the app and the firmware on our website.

https://peavey.com/software/

Email Sent

Email Sent

No...they are only cut from the amplifier outputs. If you look at the block diagram in the manual, you will see the DSP is after the analog mixer.

Email sent.

That is a two tip 1/4" jack for higher current applications. The other pin is the switching pin...but it should have no connection to the ground pin.

It should also disconnect from the tip pins when a cable is plugged in.

Going off of memory...no.

Some of them had bridged outputs, some had Speak-on outputs and some only had 1/4" outputs. I believe the output jack configuration was the main difference.

Answered

Solved in an email.

J72? I see 7N80C.

Parts Department To order replacement parts, please call us at (800) 752-7896 (toll free in the US). Our business hours are 8 a.m. - 5 p.m. Central Time, Monday-Friday. Hold times may be long during peak hours. If you have to wait on hold, feel free to leave a name and number and one of our Parts Sa...